Tabla de Contenidos: “…Basic Programming; Understanding Your Fixtures; Speed Channels; Conventional Channels; Palettes/Presets; 5. …”

Tabla de Contenidos: “…7.5 Common terminology -- 7.6 Drawbacks of differential signaling -- 7.7 References -- 7.8 Problems -- Chapter 8: Mathematical Requirements of Physical Channels -- 8.1 Frequency domain effects in time domain simulations -- 8.2 Requirements for a physical Channel -- 8.3 References -- 8.4 Problems -- Chapter 9: Network Analysis for Digital Engineers -- 9.1 High frequency voltage and current waves -- 9.2 Network Theory -- 9.3 Properties of Physical S-parameters -- 9.4 References -- 9.5 Problems -- Chapter 10: Topics in High-Speed Channel Modeling -- 10.1 Creating a physical transmission line mode -- 10.2 Non-Ideal Return Paths -- 10.3 Vias -- 10.4 References -- 10.5 Problems -- Chapter 11: I/O Circuits and Models -- 11.1 Introduction -- 11.2 Push-Pull Transmitters -- 11.3 CMOS Receivers -- 11.4 ESD Protection Circuits -- 11.5 On-Chip Termination -- 11.6 Bergeron Diagrams -- 11.7 Open Drain Transmitters -- 11.8 Differential Current Mode Transmitters -- 11.9 Low Swing/Differential Receivers -- 11.10 IBIS Models -- 11.11 Summary -- 11.12 References -- 11.13 Problems -- Chapter 12: Equalization -- 12.1 Introduction -- 12.2 Continuous Time Linear Equalizers -- 12.3 Discrete Linear Equalizers -- 12.4 Decision Feedback Equalization -- 12.5 Summary -- 12.6 References -- 12.7 Problems -- Chapter 13: Modeling and Budgeting of Timing Jitter and Noise -- 13.1 The Eye Diagram -- 13.2 Bit Error Rate -- 13.3 Jitter Sources and Budgets -- 13.4 Noise Sources and Budgets -- 13.5 Peak Distortion Analysis Methods -- 13.6 Summary -- 13.7 References -- 13.8 Problems -- Chapter 14: System Analysis Using Response Surface Modeling -- 14.1 Introduction -- 14.2 Case Study: 10 Gb/s differential PCB interface -- 14.3 RSM Construction by Least Squares Fitting -- 14.4 Measures of Fit -- 14.5 Significance Testing -- 14.6 Confidence Intervals -- 14.7 Sensitivity Analysis and Design Optimization -- 14.8 Defect Rate Prediction Using Monte Carlo Simulation -- 14.9 Additional RSM Considerations -- 14.10 Summary…”

“…The editors and contributors cover key areas in test and measurement of transmitters (digital waveform and jitter analysis and bit error ratio), receivers (sensitivity, jitter tolerance, and PLL/CDR characterization), and high-speed channel characterization (in time and frequency domain). …”