Friction stir superplasticity for unitized structures
This book describes the fundamentals and potential applications of 'friction stir superplasticity for unitized structures'. Conventional superplastic forming of sheets is limited to the thickness of 3 mm because the fine grained starting material is produced by rolling. Friction stir super...
| Other Authors: | , |
|---|---|
| Format: | eBook |
| Language: | Inglés |
| Published: |
Waltham, Massachusetts :
Butterworth-Heinemann
2014.
|
| Edition: | 1st edition |
| Series: | Friction stir welding and processing book series.
|
| Subjects: | |
| See on Biblioteca Universitat Ramon Llull: | https://discovery.url.edu/permalink/34CSUC_URL/1im36ta/alma991009628183706719 |
Table of Contents:
- Front Cover; Friction Stir Superplasticity for Unitized Structures; Copyright Page; Contents; Preface; Acknowledgments; 1 Introduction; 2 Friction Stir Microstructure for Superplasticity; 3 High-Strain-Rate Superplasticity; 3.1 Superplastic Behavior; 3.2 Microstructural Evolution During Superplastic Deformation; 4 Low-Temperature Superplasticity; 4.1 LTSP of FSP Al-Zn-Mg-Sc; 4.2 LTSP of FSP Al-Mg-Zr; 5 Superplasticity of Cast Alloy-An Example; 6 Superplastic Deformation Mechanism; 6.1 High Strain Rate Superplasticity; 6.2 Low Temperature Superplasticity; 6.3 Enhanced Deformation Kinetics
- 6.4 Superplastic Mechanism Map for FSP Aluminum Alloys7 Cavitation During Superplasticity; 7.1 Cavity Formation and Growth; 7.2 Factor Influencing Cavity Formation and Growth; 7.2.1 Strain Rate; 7.2.2 Test Temperature; 7.2.3 Grain Size; 7.3 Cavity Growth Mechanism and Critical Strain; 7.4 Comparison Between Cavitation Behaviors of FSP and TMP Aluminum Alloys; 8 Superplastic Forming of Friction Stir Processed Plates; 9 Potential of Extending Superplasticity to Thick Sections; 10 Potential of Superplastic Forming of Low-Cost Cast Plate; 11 Superplastic Punch Forming and Superplastic Forging
- 12 Friction Stir Welding and Superplastic Forming for Multisheet Structures13 Summary; References
